Micro Minim OSD для NAZE32 CC3D

Внимание! Не собранная версия(штырьковые контакты не припаяны) с прошивкой для NAZE32.

Дополнительную информацию можно посмотреть ТУТ

Особенности:

• All the same features as the orignal, but less the half the size 
• NO Dc/Dc convert . power board via 5 volts 
• FTDI cable compatible pinout
• Standard 6-pin ISP header
• Two LED indicators
• ATmega328P with Arduino bootloader
• MAX7456 monochrome on-screen display
• 16x16MM Size!
• Modifications for direct connection of two batteries (up to 4S)
• Pad for an Analog or Digital PWM RSSI signal 
• Pad for the connection of a Current Sensor
• ATmega328P with Arduino bootloader
• Standalone, or with APM/ Flip / Flip32+ flight controllers 
• These modifications allow direct connection of two batteries (up to 4S)
• Big thank you to the KV Team and the OSD firmware and the multiwii-osd team 
• This hardware take the hardware mods for this firmware, and builds them into an RTF solution.
• This Board can be used just as a normal OSD for APM or it can be used with MWC KV Team Mod .

• ATmega328P with Arduino bootloader
• MAX7456 monochrome on-screen display
• FTDI cable compatible pinout
• Standard 6-pin ISP header
• Two independent power sections with an LED indicator on each
• Solder jumpers for combining the power sections
• +5V 500mA regulator for up to +12V supply input
• Solder jumper for PAL video option
• Exposed test points for HSYNC and LOS
• Dimensions: 0.7"W x 1.7"L (2.4" w/ pins as shown) x 0.3"H
• MINIMOSD, A MINIMAL ARDUINO-BASED ON-SCREEN DISPLAY BOARD.

Комплект:

1 pc Micro Minim osd baord